![]() You need to change the contact.external-address: option in config.yaml in case of binary or -e ADDRESS parameter of docker run in case of docker to use the external address and port, i.e. ![]() If you use a binary version (or docker run with -network host), you also need to specify this port in the server.address: too. ![]() If both nodes are running on the same host, then you need to forward 28968 to 28968 and use this port in the contact.external-address: option of the config.yaml (in case of binary) or -e ADDRESS parameter of docker run in case of docker. Then you can forward this port to the internal 28967 port, if the destination local IP is different from the first node. Forwarding optionsįor example, you decided to configure your second node with port 28968. You need to make these changes for the second and any further additional nodes as well. You can also read the discussion RAID vs No RAID on our forum. Using RAID0 (LVM, spanned drives, JBOD, etc.) is not recommended - with only one disk failure the whole node is lost.Įven using RAID5/6 with today's disks is too risky due to bit failure rate on disks with high capacity: High risk to lose a RAID5 volume during rebuild. If you would like to use RAID anyway, please note - your node will not receive more customer data only because you use RAID, this will not affect the node selection. You can, of course, use RAID instead, but this reduncancy not required for the network's operation - the network itself has a built-in redundancy due to the usage of erasure codes: the customer needs only 29 pieces out of 80 to reconstruct the whole file. All nodes behind the same subnet /24 of a public IP are treated as a single node for ingress traffic and as separate ones for egress traffic (to the customers, repair and audit) - this is because we want to be decentralized as much as possible.Īdding more drives/nodes will not increase the ingress traffic, only usage by customers can do this.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |